Introducing Super Melt Welding Rods, The Simplest Way To Weld Aluminum Parts.
No Expensive Equipment Required. You only need one propane torch and some Easy Melt Welding Rod. 👍
Aluminum welding rod is a pure aluminum welding wire with an aluminum content greater than 99.7%. It is a kind of universal welding material with wide application. ⚙
Low-temperature aluminum welding wire can weld almost all white metals, including aluminum, aluminum alloy, cast aluminum, aluminum-magnesium alloy and dissimilar welding between the above metals, even for white metals that have been seriously corroded or contaminated with oil, even those that are considered irreparable. Aluminum alloys can be repaired.
Great Welding Effect - With full & smooth welding effect because of internal powder. With low melting point(647℃~658℃), great weldability and corrosion resistance, high thermal conductivity, high electric conductivity, and excellent processing performance.
No Need Solder Powder - You don't have to use other flux powder with aluminum alloy as the welding core and coating as the salt base. Very convenient and easy to weld.
Widely Use In Life - Suitable for welding or surfacing welding alloy with high strength, good mergeability & good corrosion resistance.
Very Wide Application - It is mainly used for argon arc welding and filling material for pure aluminum, connection with aluminum bus and guide rod of electrolytic aluminum plant and electric power, chemistry, food and so on.
Light Weight & Small Volume - Size of 500*2mm & weight of 3.5g, very easy to bend & carry.
Melting Point: 647℃~658℃
Diameter: 2mm / 0.08"
Length: 500mm / 19.7"
Recommended for welding or brazing aluminum alloy: 1060, 1350, 3003, 3004, 3005, 5005, 5050, 6053, 6061, 6951, 7005, and cast alloys 710.0 and 711.0
1. Thoroughly clean the area you’re about to weld by brushing the base with stainless steel brush until it becomes shiny. Then evenly heat the area to be welded.
2. As you heat, rub the rod vigorously against the heated area until the rod starts flowing.
3. Please Note: Never apply heat directly to the rod as it will crumb, and if you manage to melt the rod directly, the weld will be easily breakable. Remember, melting the rod directly is a wrong way, and makes crumby welds.